Toyota Camry

1992-1997 of release

Repair and operation of the car



Toyota Camry
+ General data
+ 1. Maintenance
- 2. Engine
   2.2. Operations on repair of the engine on the car
   2.3. Top dead point of the first cylinder
   + 2.4. Cover of a head of the block of cylinders
   + 2.5. Inlet collector
   + 2.6. Final collector
   + 2.7. Gear belt and pulleys
   2.8. Replacement of a forward sealing ring of a bent shaft
   2.9. Replacement of a sealing ring of the camshaft
   + 2.10. Camshaft and pushers
   + 2.11. Head of the block of cylinders
   + 2.12. Oil pallet
   + 2.13. Oil pump
   + 2.14. Drive flywheel / plate
   2.15. Replacement of a back sealing ring of a bent shaft
   + 2.16. Suspension bracket of the power unit
+ 3. Six-cylinder V6 engines
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Decrease in toxicity
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment


f32f416a



2.15. Replacement of a back sealing ring of a bent shaft

PERFORMANCE ORDER
1. Remove the transmission and a flywheel.

2. The easiest way of extraction old uplotnitelno го rings is in that the screw-driver to hook on a sealing ring and to take it from a nest.
3. Also sealing ring can be taken from a nest if to drill two small openings located in the opposite ends of a sealing ring in a ring. Screw in two self-cutting screws in the drilled openings of a sealing ring and, using flat-nose pliers, extend a sealing ring for heads of screws.
4. The most reliable method of replacement of a back sealing ring of a bent shaft is that it is necessary to remove the oil pallet and a back cover of a bent shaft together with a sealing ring.

5. Establish a back cover of a bent shaft together with condense with a telny ring on wooden whetstones and, using the hammer and the screw-driver, beat out an old sealing ring from a cover.
6. Using wooden whetstone and the hammer, establish a new sealing ring of a bent shaft in a back cover.
7. Clear the interfaced surfaces of the block of cylinders and a back cover of a bent shaft and install new laying on the block of cylinders.
8. Being careful, establish a back cover with condense with a telny ring on the engine.
9. Fix a back cover of a bent shaft by bolts, having tightened them the required moment, at the same time the lower edge of a back cover has to be flush with bottom edge of the block of cylinders of the engine.

10. Further installation is made in the sequence, the return to removal.

On the homepage