1992-1997 of release
Repair and operation of the car
+ General data
+ 1. Maintenance
+ 2. Engine
- 3. Six-cylinder V6 engines
3.2. General information
3.3. The repair which is not demanding removal of the engine
- 3.4. Top Dead Point (TDP) of the piston of the first cylinder
3.4.1. Engine 3VZ-FE
3.4.2. Engine 1MZ-FE
+ 3.5. Cover of a head of the block of cylinders
+ 3.6. Inlet collector
3.7. Final collector
+ 3.8. Gear belt and pulleys
3.9. Replacement of a forward sealing ring of a bent shaft
3.10. Replacement of sealing rings of camshafts
+ 3.11. Camshafts and pushers
+ 3.12. Head of the block of cylinders
+ 3.13. Oil pallet
+ 3.14. Oil pump
3.15. Drive flywheel / plate
3.16. Replacement of a back sealing ring of a bent shaft
3.17. Suspension bracket of the power unit
+ 4. Capital repairs of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Decrease in toxicity
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment
The sequence of operations is made proceeding from the assumption that the distributor of ignition is installed correctly. If it is necessary to define the top dead point for installation of the distributor, then install the piston of the first cylinder in the top dead point in a compression step, then expose ignition tags.
The top dead point of the piston is a point through which there passes each piston at a provorachivaniye of a bent shaft. Each piston reaches the provision of VMT at the end of a step of compression then again at the end of an exhaust step. For the purpose of installation of the mechanism of gas distribution of the engine the top dead point of the piston of the first cylinder is used.
The piston arrangement precisely in the top dead point is extremely important when carrying out many works, for example, at removal of the camshaft, a gear belt and a pulley of the camshaft and distributor of ignition.
Before works on installation of the piston of the first cylinder in the top dead point, be convinced that the lever of gear shifting is in neutral situation, and the emergency brake is tightened. Disconnect system of ignition, having taken out the central wire from a cover of the distributor and having grounded it on weight. Unscrew spark plugs.
For installation of any of pistons in the top dead point rotate a bent shaft one of the methods described below. At the same time rotate a bent shaft of the engine clockwise.
The most preferable method is a provorachivaniye of a bent shaft of the engine for a bolt of fastening of a pulley of a bent shaft.
For saving of time it is possible to use a starter for a piston supply to the top dead point. Exact installation of the piston is carried out by turn of a bent shaft for a bolt of fastening of a pulley of a bent shaft to the top dead point.
On the homepage