1992-1997 of release
Repair and operation of the car
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
- 4. Capital repairs of engines
4.2. General information
4.3. Check of a compression
4.4. Recommendations about removal of the engine
+ 4.5. Removal and installation of the engine
4.6. Sequence of dismantling of the engine
4.7. Dismantling of a head of the block of cylinders
+ 4.8. Cleaning and survey of a head of the block of cylinders
4.9. Assembly of a head of the block of cylinders
4.10. Removal of pistons with rods
4.11. Removal of a bent shaft
+ 4.12. Block of cylinders of the engine
4.13. Pistons and rods
4.14. Bent shaft
+ 4.15. Survey and choice of radical and conrod bearings
4.16. Control of a side play of assembly of the balance weight (engine 5S-FE)
4.17. Engine balance of assembly at capital repairs
4.18. Installation of piston rings
+ 4.19. Installation of a bent shaft and check of working gaps of bearings
4.20. Installation of a back sealing ring of a bent shaft
4.21. Installation of pistons and rods, check of working gaps of bearings
4.22. Installation of assembly of the balance weight (engine 5S-FE)
4.23. Start of the engine after capital repairs
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. System of ignition
+ 8. Decrease in toxicity
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment
This section included the general methods of dismantling of a head of the block of cylinders and other knots of the engine.
Information concerns the sequence of preparation for repair and the step-by-step description of operations of removal and installation of components of the engine and their check.
It is not always easy to define as where in the engine demands repair: too many factors should be taken into account. The big run of the engine is not always a prerequisite to repair and vice versa, the small run does not guarantee lack of need under repair.
The raised consumption of oil testifies to need to pay attention to a condition of piston rings, maslosjy ny caps and guides of valves. At making decision on repair of the specified knots certify in lack of a leak of oil. Measurement of a compression in engine cylinders can give additional information on volumes of repair.
Check oil pressure size by means of the manometer installed instead of the oil pressure sensor. The lowered size of pressure of oil testifies to wear of bearings or damage of the oil pump.
Falling of power, uneven operation of the engine, blows and mechanical noise, the increased noise of the valvate mechanism and high fuel consumption, as a rule, testifies to need of repair, especially, if all these troubles arose at the same time.
On the homepage